| 李昭勇,赵芸,庄晓雯,等.响应面法优化海藻酸钠-结冷胶复合膜抗水性能[J].中国海洋药物,2020,39(5):45-51. |
| 响应面法优化海藻酸钠-结冷胶复合膜抗水性能 |
| Response Surface Methodology optimize water resistance of alginate/gellan blend films |
| 投稿时间：2020-08-17 修订日期：2020-08-27 |
| DOI： |
| 中文关键词: 海藻酸钠 结冷胶 复合膜 抗水性 响应面分析 |
| English Keywords:NaAlg gellan blend films water-resistance Response Surface Methodology（RSM） |
| Fund Project: |
|
| 摘要点击次数: 3598 |
| 全文下载次数: 623 |
| 中文摘要: |
| 目的 采用响应面法优化海藻酸钠-结冷胶复合膜制备工艺，提高其抗水性能。方法 以透水率和溶胀度为考核指标，选取共混液总浓度、组分比例、丙三醇浓度、钙离子浓度、交联时间和干燥温度为考察因素，利用Plackett-Burman（PB）实验筛选出了对实验影响最为显著的三个因素，然后通过最陡爬坡试验进一步缩小考察范围和确认中心点，最后利用Box-Behnken（BB）实验确定最优工艺条件。结果 对实验影响最为显著的三个因素分别为：组分比例、钙离子浓度、总浓度；实验的最优工艺条件为：组分比例201.64%、钙离子浓度5.05%、总浓度2.41%，丙三醇浓度0.5%，交联时间5 min，干燥温度50℃，在此工艺条件下的透水率和溶胀度分别为72.28×10-8 g/msPa，66.09%。 |
| English Summary: |
| Abstract: Objective To optimize the water resistance of alginate/gellan blend films by response surface methodology. Methods Making the total concentration, component ratio, plasticizer concentration, crosslinking agent, crosslinking time ?and dry temperature as the investigated factors, based on the previous single factor experiments, to determine the central point of response surface methodology. Conclusion The three factors which impact the experiment most: component ratio, Ca2+ concentration and total concentration; the optimal condition: component ratio, 201.64%; Ca2+ concentration, 5.05%; total concentration, 2.41%; plasticizer, 0.5%; crosslinking time, 5 min; and dry temperature, 50℃, WP and SD are 72.28×10-8 g/msPa, 66.09% respectively with these condition. |
| 查看全文 查看/发表评论 下载PDF阅读器 |
|
| 关闭 |
|
|
|